Sportsman 3,500-Watt Dual Fuel Generator/Welder

The Sportsman 4000/3500-Watt Dual-Fuel Generator/Welder has everything you need for the job in one package. Able to handle the needs of most contractors, this dual-fuel generator/welder is also great for homeowners and recreational activities. Equipped with four 120 Volt outlets and a whole lot more, this dual-fuel generator/welder can handle almost everything you need at the job site. Try Sportsman’s versatile dual-fuel generator/welder today!

• Great dual-fuel generator/welder for a variety of applications
• 4,000 surge watts and 3,500 running watts can run the RV, household appliances, and power tools
• Dual-fuel generator/welder utilizes either unleaded gasoline or LPG propane gas a s a fuel source (propane tank not included)
• 7.0 HP engine, 4 stroke, 212cc, air cooled, recoil start, OHV 4 stroke engine with AVR, recoil start, single phase
• Dual-fuel generator/welder offers: 9 hour run time with a 50 percent load on an full 3.2 gal. gas tank, or 12 hours with a full 20 lb. propane tank
• (4) 120V AC outlets (each 20 amps), (1) 120V RV outlet (30 amps), (1) 12V DC outlet (8 amps) for battery charging, circuit protection
• AC/DC circuit reset, engine shut off switch, welding power switch, low oil shutdown; oil capacity: 18.5 oz. SAE 10W30,
• Dual-fuel generator/welder puts out less than 69 dB noise with no load at 23 ft.
• Comes with a DC connector wires for charging 12 Volt automotive-type batteries, a spark plug wrench, and a 5 ft. regulator hose kit
• Surge watts / running watts may be reduced by 10% when using propane fuel vs. gasoline
• EPA approved, Non-CARB compliant/Not for sale in California
• High altitude use: this generator is not recommended for high altitude use above 3,000 ft.
• Inverter power manages input fluctuations for better welds and more control
• Comes TIG ready for scratch start, over/low voltage protection, anti-sticking, and hot start
• Welds mild steel, stainless steel, cast iron, and hard surfacing
• Powered by the generator, 120V input, 60Hz, 25.75 amps, single phase
• 76V DC no load voltage, duty cycle 25% at 85A, 10 to 85 AMP DC output range
• Uses 1/16, 5/64, and 3/32 inch (1.6-2.5mm) electrodes, E6013, E7014, E7018, and stainless steel suggested
• Dual-fuel generator/welder equipped with 6 ft. welding cable with electrode holder, 6 ft. ground cable with earth clamp, face mask, and wire brush